I have a problem to unistall Evade 2 from my Arduboy.
When i connect it on my pc, it’s only recognized when i reset with the UP-LEFT-A-B, but for only few seconds.
I think you need to time it correctly … Start an upload and then press the key sequence. If you get the timing right, it will latch on and upload.
Enable verbose outputs in settings, then when you see the ports message on uploading press the button combo.
I use the Arduboy Game Manager.
The Transfer button is unclickable. It’s possible to click only in this few second, but the arduboy is immediatly disconnect and then it restart.
Excuse me, but i’ma a noob with Arduino.
How can i connect my Arduboy with Arduino software ?
I didn’t realize you used Arduboy Game Manager
For Getting started with Arduino check out Make Your Own Arduboy Game: Part 1 - Setting Up Your Computer
I have made it.
what can i do to make the instructional video in the original post more clear for resetting an arduboy after installing this game?
Is there a way to turn sound off?
Through code only. IIRC, the main file has a preprocessor directive that you can use to disable all sound.
Haven’t seen anything even CLOSE to it…
Damn, that’s awesome.
But it might be a bit overkill and confusing (very confusing) at first.
But yeah, such big game means you can’t have flash light mode and not even a sound menu
Since i’m fairly new to the arduboy and familiar with very little programming, i was wondering is there a place where there are step by step instructions on how i can download this game to my arduboy?
There’s a guide for uploading hex files using community-made tools here:
There’s a guide for how to compile from source code here:
Be warned that Evade2 is harder to remove than a normal Arduboy game.
You have to use this special procedure:
I would advise trying a different game first and coming back to this one later.
EVADE - side scrolling space shooter
I love the flipping Evade 2 (and can’t think of a reason for it to stop flipping)
release some PROGMEM by not having it stop flipping…
I like the effect, But I don’t feel comfortable with the flipping “Get Ready”…
Maybe a flickering(if too complicated, “booting”) HUD at the beginning is better.
That seems overkill.
That seems enough but think we can have a bit more.
Appreciate effort, nice game, maybe overkill but is ok
'cause I like it.
Feel free not to enjoy it.
@CDR_Xavier you really need to consider what you are saying before pressing the reply button.
really very well done!
After I downloaded Evade 2 my usb port option has disappeared from the ports menu. Is that normal? I’m trying to follow the video for how to load a different game and I don’t quite understand it. I downloaded Visual Studio Code to run the cal.sh file from the evade2 folder but I can’t do much if Arduino is not recognising my usb port. Can anyone make this process more clear for me?
Easiest way would be to use the reset button. When the reset is pressed it enters the bootloader mode for a few seconds. If timed correctly you can flash a new game within that time limit.