Hey everyone. I’m new to arduboys (and new to Arduinos in general), first time programmer here with some setup questions. If any of this can be referenced elsewhere or similarly attributed to my inexperience, apologies in advance, but any heads up in the right direction is likewise appreciated.
As of right now, I have an oled screen that is compatible (and tested) through the same ssd1306 libraries I see works with the arduboy, but how would I go about setting up/configuring the buttons, etc? Haven’t done anything else yet so far as software or hardware goes, just the screen, but I’ve already installed the arduboy libraries as well, just not sure where else to take it from here.