Problem uploading code to the board

When I upload the code on the board, this message appears to me. I have already uploaded the code and this problem did not occur with me. But today, suddenly, this problem came up. I changed the code and changed the computer.

That doesn’t look like Arduboy code. The Arduboy doesn’t have any servos.

1 Like

I tried more than one code all the same error knowing that I had tried the code previously and was turned on

Are you sure you’ve got the board type correct?
That says like you’re trying to upload to an Uno.

Also have you looked at either of these?:

1 Like

sure yeah …

this arduino is old not new